8 mm Solderless Jumper Connectors for LED Strip Lights
The FLUFLUX 8 mm solderless jumper connector joins two cut sections of 8 mm LED strip, or carries a run around a corner, with no soldering. Cut the strip at a marked cut line, slide it into the connector and tighten the two screws.
Product Features
- Pre-installed 6 in. (152 mm) 20 AWG lead, red (+) and black (−)
- Solderless: screw-down terminals tightened with a 2 mm Phillips screwdriver
- Pre-installed 3M VHB adhesive on the back for secure mounting
- Fits 8 mm single-color strip: Fluflux WAVE 24V COB (3 W/ft) and WAVE 12V COB
- 12–24V DC; up to 5 A at 12V or 4 A at 24V
- Transparent housing to check the strip is fully seated
Compatibility
- For 8 mm single-color strips: Fluflux WAVE 24V COB (3 W/ft) and WAVE 12V COB
- Not for 10 mm strips (WAVE+, LINE and LINE+); use the 10 mm connectors
- Not for multi-channel strips such as RGB or tunable white
Package Includes
- 10 × 8 mm solderless jumper connectors with 6 in. leads
- 1 × 2 mm Phillips screwdriver for the terminal screws
Installation Notes
- Cut the strip only at a marked cut line.
- Match polarity: strip (+) to the red wire and (−) to the black wire.
- Tighten the screws securely, but do not overtighten; that can crack the connector.
- The 3M VHB tape adds about 0.04 in. of height; peel it off if the connector does not fit the channel.
- For indoor use, -4°F to 122°F (-20°C to 50°C).
Your selection
- SKU
- Link01-8mm-TJ-6IN-10
- Type
- Jumper connector
- Board width
- 8 mm single-color strip
- Package
- 10 connectors + 2 mm Phillips screwdriver
Compatibility
- Fits
- Fluflux WAVE 24V COB and WAVE 12V COB
- Use
- Joins two cut sections or turns a corner
- Not for
- 10 mm strips (use the 10 mm connectors), or multi-channel (RGB, tunable white) strips
Electrical
- Voltage
- 12–24V DC
- Max current
- 5 A at 12V · 4 A at 24V
- Lead
- 6 in. (152 mm), 20 AWG, red (+) / black (−)
Installation
- Terminals
- Screw-down, 2 mm Phillips
- Mounting
- 3M VHB tape, pre-installed
- Environment
- Indoor
- Ambient temp.
- -4°F to 122°F (-20°C to 50°C)
The pre-installed 3M VHB tape adds about 0.04 in. of height; peel it off if the connector does not fit the channel.
