10 mm Solderless Power Connectors for LED Strip Lights
The FLUFLUX 10 mm solderless power connector connects a cut 10 mm LED strip to its power supply, with no soldering. Cut the strip at a marked cut line, slide it into the connector and tighten the two screws.
Product Features
- Pre-installed 6 in. (152 mm) 20 AWG lead, red (+) and black (−)
- Solderless: screw-down terminals tightened with a 2 mm Phillips screwdriver
- Pre-installed 3M VHB adhesive on the back for secure mounting
- Fits 10 mm single-color strip: Fluflux WAVE+ 24V COB (5 W/ft), LINE and LINE+ 24V 2835
- 12–24V DC; up to 5 A at 12V or 4 A at 24V
- Transparent housing to check the strip is fully seated
Compatibility
- For 10 mm single-color strips: Fluflux WAVE+ 24V COB (5 W/ft), LINE and LINE+ 24V 2835
- Not for 8 mm strips (WAVE 24V and WAVE 12V); use the 8 mm connectors
- Not for multi-channel strips such as RGB or tunable white
Package Includes
- 10 × 10 mm solderless power connectors with 6 in. leads
- 1 × 2 mm Phillips screwdriver for the terminal screws
Installation Notes
- Cut the strip only at a marked cut line.
- Match polarity: strip (+) to the red wire and (−) to the black wire.
- Tighten the screws securely, but do not overtighten; that can crack the connector.
- The 3M VHB tape adds about 0.04 in. of height; peel it off if the connector does not fit the channel.
- For indoor use, -4°F to 122°F (-20°C to 50°C).
Your selection
- SKU
- Link01-10mm-TP-6IN-10
- Type
- Power connector
- Board width
- 10 mm single-color strip
- Package
- 10 connectors + 2 mm Phillips screwdriver
Compatibility
- Fits
- Fluflux WAVE+ COB, LINE and LINE+ 2835
- Use
- Feeds power into the start of a run
- Not for
- 8 mm strips (use the 8 mm connectors), or multi-channel (RGB, tunable white) strips
Electrical
- Voltage
- 12–24V DC
- Max current
- 5 A at 12V · 4 A at 24V
- Lead
- 6 in. (152 mm), 20 AWG, red (+) / black (−)
Installation
- Terminals
- Screw-down, 2 mm Phillips
- Mounting
- 3M VHB tape, pre-installed
- Environment
- Indoor
- Ambient temp.
- -4°F to 122°F (-20°C to 50°C)
The pre-installed 3M VHB tape adds about 0.04 in. of height; peel it off if the connector does not fit the channel.
